Shure ULXD24/SM58 Wireless ULX-D Handheld SM58 Microphone and Case

  

Shure ULX-D Handheld Wireless Microphone System with SM58 and Case. The Shure ULXD4 is a half-rack, networkable wireless receiver for use with ULX-D Digital Wireless Systems. With an expansive set of professional features, including 24-bit / 48 kHz digital audio quality, efficient and intelligent RF performance, and AES 256-bit encryption, ULX Digital offers uncompromising wireless tailored for professional sound reinforcement.

High Density mode optimizes ULX-D systems to simultaneously operate significantly more channels in applications up to 30 meters. Intelligent scanning automatically finds and deploys the cleanest frequencies to transmitters over IR sync. Interference detection and alerts provided on both the receiver and Wireless Workbench 6. Front panel gain adjustment buttons provide up to 60 dB additional gain.

AES 256-bit encryption-enabled for applications where secure transmission is needed. Ethernet networking provides streamlined setup across multiple receivers, Wireless Workbench® 6 integration, and AMX/Crestron control. Support for frequency coordination with the Axient® Spectrum Manager. Yamaha device ID allows simplified channel patching on CL consoles. Intuitive front panel LCD menu and controls with lockout feature.

Upgraded LCD with adjustable contrast and brightness. Audio and RF LED meters with peak indicator.

RF Carrier Frequency Range: 470-534 MHz. Working Range: 330 ft (100 m) line of sight. Image Rejection: >70 dB, typical. RF Sensitivity: -98 dBm at 0.0001 BER.

Latency, Standard Mode: 2.9 ms. Audio Frequency Response: 20 - 20 kHz (+/-1 dB) Note: Dependent on microphone type.

Operating Temperature Range: -18°C (0°F) to 50°C (122°F). Gain Adjustment Range: -18 to +42 dB in 1 dB steps (plus Mute setting).

Full Scale Output, XLR: LINE setting: +18 dBV, MIC setting: -12 dBV. Shure RF Carrier Band: G50. Full Scale Output, 1/4:+12 dBV. Latency, High Density Mode: 3.2 ms. Dimensions, L x W x H: 7.8" x 6.7" x 1.7 (197 mm x 171 mm x 42 mm).

Weight: 2.0 lbs (0.9 kg), without antennas. Network Interface: Single Port Ethernet 10/100 Mbps. Network Addressing Capability: DHCP or Manual IP address, with or without gateway. Audio Dynamic Range: Analog Output: >120 dB, A-weighted. The ULXD2 Handheld Wireless Microphone Transmitter works with ULX-D Wireless Systems.

With the ability to accept any of the Shure interchangeable microphone cartridges, the ULXD2 delivers uncompromising audio quality and RF performance, and AES 256-bit encryption for secure transmission. Works with ULX-D® Wireless Systems. AES 256-bit encryption for applications for which secure transmission is needed. Proprietary Shure Gain Ranging optimizes the system's dynamic range for any input source, eliminating the need for transmitter gain adjustments. Optional Shure SB900 lithium-ion rechargeable battery pack provides over 12 hours of battery life, precision metering in hours and minutes, and zero memory effect. External charging contacts for docked charging (with the SBC200 Dual Docking Charger). Transmitter Mute Mode repurposes the On/Off switch into a mute switch, enabling audio muting while preserving RF channel presence. Backlit LCD with easy to navigate menu and controls.

Gain Offset Range: 0 to 21 dB (in 3 dB steps). Battery Type: Shure SB900 Rechargeable Li-Ion or LR6 AA batteries 1.5 V. Dimensions: 256 mm x 51 mm 10.1 in. Weight: 340 g 12.0 oz.

Maximum Input Level 1 kHz at 1% THD: 145 dB SPL (SM58), typical. Preamplifier Equivalent Input Noise (EIN), System : 120 dBV, A-weighted, typical. Antenna Type: Integrated Single Band Helical. Modulation Type: Shure Proprietary Digital. Power: 1 mW, 10 mW, 20 mW. Frequency Range: G50 Band (470 to 534 MHz). This iSeries case was designed to hold the Shure BLXR, GLXDR, SLX, SLX-D, QLX-D, and ULX-D wireless systems. The custom interior foam can accommodate the receiver, quarter and a half wave antenna, handheld mic, bodypack transmitter, lavalier mic, earset head-worn mic, rechargeable battery/AA batteries, mic clip, and power supply. SKB iSeries Injection Molded Mil-Standard Waterproof Cases are molded of ultra high-strength polypropylene copolymer resin, featuring a gasket-sealed, water and dust tight, submersible design (MIL-STD 810G) that is resistant to corrosion and impact damage. Standard features include a molded-in hinge, patented trigger release latches, snap-down rubber over-molded cushion grip handle, automatic ambient pressure equalization valve (MIL-STD 810G), and resistance to UV, solvents, corrosion, fungus and impact damage (MIL-STD 810G). Fits Shure BLXR, GLXDR, SLX, SLX-D, QLX-D, and ULX-D wireless systems. Space for receiver, antennas, handheld mic, bodypack transmitter, and accessories. Ultra high-strength polypropylene copolymer resin. Resistant to UV, solvents, corrosion, fungus, and impact damage (MIL-STD 810G). Complete gasket seal makes these cases absolutely watertight (MIL-STD 810G).

Automatic ambient pressure equalization valve. Rubber over-molded cushion grip handle. Locking loops accept a customer supplied lock. The RPW112 is the Cartridge, Housing Assembly and Matte Grille for Wireless SM58.

This is a direct replacement for the microphone cartridges in Shure's L, LX, T, EC, SC, UC, ULX, SLX, Performance Gear, UHF, and UHF-R Series hand-held wireless microphone- transmitters. These replacement cartridges are electrically and mechanically interchangeable with any Shure hand-held microphone-transmitter. The cartridges are supplied with a. (0.9 mm) hexagonal-head wrench that is necessary for cartridge removal and installation on some models. Works for any Wireless SM58. Works for the following Shure Wireless series: L, LX, T, EC, SC, UC, ULX, SLX, Performance Gear, UHF, UHF-R, Axient, SLX-D, QLX-D, ULX-D, Axient Digital. This item is in the category "Musical Instruments & Gear\Pro Audio Equipment\Microphones & Wireless Systems". The seller is "avbyfp" and is located in this country: US.

This item can be shipped to United States.

1. Brand: Shure
2. Form Factor: Table Top
3. Polar Pattern: Cardioid
4. Bundle Description: Includes Waterproof Case
5. Custom Bundle: Yes
6. Model: ULXD24/SM58
7. Connectivity: XLR 3 Pin, 6.35 mm (1/4 in) TRS